I recently purchased a L. Power & Co. 12″ jointer. It is massive and made completely of cast iron.
I got a great deal on the jointer but of course I had to move it from its current location to my new shop. This presented some challenges. Here is the video of the move.
To get the job done I enlisted the help of my Dad and a few friends, Gib Clark and Mark Saunders. Gib is one of those guys who knows a lot about a lot of things and he was instrumental in getting this job done. Mark was generous enough to let us use his truck to haul the jointer in the U-Haul trailer that I rented and my Dad was the extra muscle.
We stated moving the jointer by removing the 3 phase 5 horsepower motor and blade guard. This just make the jointer a little easier to maneuver through the shop. Then we slid the jointer on to a 2×12 and used a pry bar to get some short lengths of conduit pipe under the 2×12. This allowed us to roll the jointer to the other end of the shop where the garage door was located.
Once we had the jointer to the door we were fortunate enough to be able to use the owner’s Bobcat to lift the jointer out of the shop and onto the trailer that I rented.
Gib brought some tow straps that we used to provide spots to lift the jointer from using the forks on the Bobcat. Once we got the jointer off the ground, placing it in the trailer was a piece of cake.
From there is was only a 3 mile drive to my shop. At my shop we unloaded the jointer using a chain fall that Gib attached to a beam on my ceiling with some steel rope. We simply backed the trailer into my shop, and used the same tow straps to attach the jointer to the chain fall. We then very easily lifted the jointer off of the trailer and drove the trailer out from under it.
To get the jointer into its spot in my shop we lowered it on to the metal conduit pipes again and rolled it into place.
This could have been a much more difficult process and I really want to thank my Dad, Gib and Mark for all their help. I never could have done it with out them.
If you like my work, consider supporting McCauley’s Design on Patreon.